Engine Mounting

Components and Component Location

Components

Repair Procedures

Removal and Installation

Engine Mounting Bracket

1. 1

   Remove the engine room cover.

   (See Engine and Transaxle Assembly - Under Hood)

2. 2

   Place a jack under the edge of the oil pan to support the engine.

   

3. 3

   Remove the engine mount support bracket (A).

   Tightening Torque

   Nut (B):

   88,3–108 N·m

   Bolts and nuts (C):

   58,8–74 N·m

   

4. 4

   Separate the reservoir tank to make room for removing the engine support bracket.

   (See Cooling System - Reservoir Tank)

5. 5

   Remove the engine mounting bracket (A).

   Tightening Torque: 49.0–64 N·m

   

6. 6

   Install in the reverse order of removal.

Roll Rod Bracket

1. 1

   Remove the engine room cover.

   (See Engine and Transaxle Assembly - Under Hood)

2. 2

   Remove the idler arm bracket (A).

   Tightening Torque

   Bolt (B):

   107,9–128 N·m

   Bolt (C):

   49,0–64 N·m

   

3. 3

   Remove the roller rod support bracket (A).

   Tightening Torque: 49.0–69 N·m

   

4. 4

   Install in the reverse order of removal.

Transaxle Mounting Bracket

1. 1

   Disconnect the negative battery cable.

2. 2

   Remove the engine room cover.

   (See Engine and Transaxle Assembly - Engine Room Under Cover)

3. 3

   Remove the air cleaner assembly.

   (See Intake and Exhaust System - Air Cleaner)

4. 4

   Remove the battery and battery tray.

   (Refer to Engine Electrical System - Battery)

5. 5

   Place a jack under the transaxle to support it.

   

6. 6

   Remove the transaxle mounting side panel seal (A).

   

7. 7

   Remove the bolt (A) from the transaxle support bracket.

   Tightening torque: 98.1 - 118 N·m

   

8. 8

   Remove the transaxle mounting bracket (A).

   Tightening Torque: 49.0–64 N·m

   

9. 9

   Install in the reverse order of removal.