Kia Optima Hybrid Owner's Manual Quiz
Body Electrical System

Room Lamp Repair Procedures

In this manual: Body Electrical System
General Information — 4Engine Mechanical System — 50Engine Electrical System — 20Emission Control System — 30Engine Control System/Fuel System — 84Automatic Transmission — 98Drive Shaft and Axle — 15Suspension System — 36Steering — 12Restraints — 50Brake System — 38Body (Interior and Exterior) — 54Body Electrical System — 233Heating, Ventilation, and Air Conditioning — 57
12steps
~72min
3/5difficulty
Done 0 of 12

Inspection

Map lamp
  1. Make sure the switch operates properly after disconnecting the interior lamp connector (A).
    [Type]
    [Type B]

Removal

Map lamp
  1. Disconnect the negative (-) battery terminal.
  2. Carefully remove the lens (A) from the room lamp using a flat-tip screwdriver.
    Be careful not to damage the part (B).
    [Type]
    [Type B]
  3. Replace the bulbs (A) and remove the screws, if necessary.
  4. Remove the interior lamp assembly (A) after disconnecting the connector (B).
  5. Disconnect the negative (-) battery terminal.
  6. Remove the vanity lamp (A) by pressing the clip (B) with a small screwdriver.
  7. Remove the vanity lamp assembly after disconnecting the connector.
Vanity lamp

Installation

Map lamp
  1. Connect the connector.
  2. Install the room lamp assembly.
  3. Install the lens.
  4. Reconnect the vanity lamp connector.
  5. Install the vanity lamp.
Vanity lamp

Test yourself

A quick Kia Optima Hybrid Owner's Manual quiz: every answer comes with an explanation and a link to the manual page.