Kia Stinger CK Quiz
Front Seat Belt

Rear Seat Back Cover

In this manual: Front Seat Belt
General Information — 8Maintenance — 27Engine Mechanical System — 47Engine Electrical System — 19Emission Control System — 12Engine Control System/Fuel System — 51Automatic Transmission System — 34All-Wheel Drive (AWD) System — 7Drive Shaft and Axle — 15Suspension System — 25Steering — 8Restraints — 19Brake System — 22Body (Interior and Exterior) — 47Front Seat Belt — 63Body Electrical System — 99Windshield Wiper/Washer — 11Heating, Ventilation, and Air Conditioning — 32
21steps
~126min
5/5difficulty
Done 0 of 21

Components and Component Location

Component Location

1. Rear Seat Assembly [LH]
2. Rear Seatback Assembly [LH]		 3. Rear Seatback Assembly [RH]
4. Rear Side Seat Assembly [RH]

Repair Procedures

Replacement

[LH]

  1. Remove the rear seat assembly.

    (Refer to Rear Seat - "Rear Seat Assembly")

  2. Press the stopper pin and remove the rear seat headrest (A).

  3. Remove the rear seatback hinge bushing (A) using a removal tool.

  4. Remove the rear seatback folding handle cover (A) using a removal tool.

  5. Remove the child anchor cover (A) using a removal tool.

  6. Separate the rear seatback trim (A).

  7. Pull out and remove the rear seat headrest guides (A) by holding both sides of the lower part of the guides.

  8. Remove the front seatback trim (C) after removing the hook-and-loop tape (A) and the ring clip (B).

  9. Install in the reverse order of removal.

[RH]

  1. Remove the rear seat assembly.

    (Refer to Rear Seat - "Rear Seat Assembly")

  2. Press the stopper pin and remove the rear seat headrest (A).

  3. Remove the rear seatback hinge bushing (A) using a removal tool.

  4. Remove the rear seatback folding handle cover (A) using a removal tool.

  5. Remove the rear center seat belt cover (A) using a removal tool.

  6. Remove the child anchor cover (A) using a removal tool.

  7. Separate the rear seatback trim (A).

  8. Remove the rear armrest (C) after removing the cover (A) and then loosening the bolt (B).

  9. Remove the rear seat armrest rear panel (A).

  10. Pull out and remove the rear seat headrest guides (A) by holding both sides of the lower part of the guides.

  11. Remove the front seatback trim (C) after removing the hook-and-loop tape (A) and the ring clip (B).

  12. Install in the reverse order of removal.

Test yourself

A quick Kia Stinger CK quiz: every answer comes with an explanation and a link to the manual page.