Liftgate

Components and Component Location

Components

Repair Procedures

Adjustment

Window Adjustment

1. 1

   Remove the rear door trim.

   (Refer to Rear Door - Rear Door Trim Panel)

2. 2

   Remove the rear door glass mounting hole plug (A).

   

3. 3

   Carefully slide the front door glass (A) until the glass mounting bolts are visible, then loosen them.

   

4. 4

   Make sure the glass moves smoothly.

Door Latch Adjustment

1. 1

   Remove the rear door latch rear cover.

2. 2

   Loosen the bolts (A) just enough to allow the tongue to move.

   Tightening torque: (B): 16.7–22 N·m

   

3. 3

   Tap the striker with a plastic hammer to adjust it. The striker will not move much, but will allow some adjustment.

4. 4

   While holding the outside handle, press the door against the body to make sure the striker allows a flush fit. If the door latches correctly, tighten the screws and recheck.

Door Position Adjustment

1. 1

   Make sure the door and body edges are parallel.

   

2. 2

   When adjusting the doors, place the vehicle on a hard, level surface.

3. 3

   Adjust at the hinges (A):

   • Slightly loosen the door mounting bolts and move the door inward and outward until it is flush with the body.

   • Slightly loosen the hinge mounting bolts and move the door rearward and forward or up and down as necessary to align the gaps.

   • Place a shop towel on the jack to avoid damaging the door when adjusting the door.

   Tightening torque:

   (B): 21,6–26 N·m

   (C): 37,3–41 N·m

   

4. 4

   Apply grease to the hinge moving parts indicated by the arrows.

5. 5

   Check for water leaks.