Kia Stinger CK Quiz
Restraints

Seat Belt Buckle Switch (BS)

In this manual: Restraints
General Information — 8Maintenance — 27Engine Mechanical System — 47Engine Electrical System — 19Emission Control System — 12Engine Control System/Fuel System — 51Automatic Transmission System — 34All-Wheel Drive (AWD) System — 7Drive Shaft and Axle — 15Suspension System — 25Steering — 8Restraints — 19Brake System — 22Body (Interior and Exterior) — 47Front Seat Belt — 63Body Electrical System — 99Windshield Wiper/Washer — 11Heating, Ventilation, and Air Conditioning — 32
7steps
~42min
2/5difficulty
Done 0 of 7

Description and Operation

Description

The SRSCM monitors the buckle status of the driver and front passenger seat belts. The SRSCM provides one pin each for the driver and front passenger seat belt buckle status input. The seat belt buckle circuit operates from the internal amplifier voltage supplied by the SRSCM and uses the body ground for the signal return. The buckle status changes the SRSCM deployment. If the seat belt is not fastened, the corresponding pretensioner will not be deactivated.

Components and Component Location

Components

1. Seat Belt Buckle Switch (BS)

Repair Procedures

Removal

  1. 1. Disconnect the negative battery terminal and wait at least three minutes before starting work.

  2. Remove the front seat assembly.

    (Refer to Body - "Front Seat Assembly")

  3. Loosen the mounting bolt and remove the seat belt buckle switch.

Installation

  1. Disconnect the negative battery terminal and wait at least three minutes before starting work.

  2. Install in the reverse order of removal.

  3. Reconnect the negative battery terminal.

  4. After installing the seat belt buckle switch, check that the system operates correctly:

    • Turn the ignition on. The SRS indicator should illuminate for approximately six seconds, then turn off.

Test yourself

A quick Kia Stinger CK quiz: every answer comes with an explanation and a link to the manual page.