Kia Stinger CK Quiz
Restraints

Front Impact Sensor (FIS)

In this manual: Restraints
General Information — 8Maintenance — 27Engine Mechanical System — 47Engine Electrical System — 19Emission Control System — 12Engine Control System/Fuel System — 51Automatic Transmission System — 34All-Wheel Drive (AWD) System — 7Drive Shaft and Axle — 15Suspension System — 25Steering — 8Restraints — 19Brake System — 22Body (Interior and Exterior) — 47Front Seat Belt — 63Body Electrical System — 99Windshield Wiper/Washer — 11Heating, Ventilation, and Air Conditioning — 32
8steps
~48min
3/5difficulty
0102030405011.79N·mlb·ft
Tightening torque found on this page
Done 0 of 8

Description and Operation

Description

  • The Front Impact Sensor (FIS) is installed in the Front End Module (FEM).

  • The FIS is a remote sensor that detects acceleration caused by a collision at its installation location.

  • The main purpose of the Front Impact Sensor (FIS) is to provide impact detection. The FIS sends acceleration data to the SRSCM.

Components and Component Location

Components

1. Front Impact Sensor (FIS)

Repair Procedures

Removal

  1. Disconnect the negative battery cable and wait at least thirty seconds before starting work.

  2. Disconnect the front impact sensor connector (A).

  3. Remove the front impact sensor mounting bolt (A).

Installation

  1. Install a new front impact sensor.

  2. Tighten the front impact sensor mounting bolt.

    Tightening torque: 7.8–11.7 N·m

  3. Connect the front impact sensor.

  4. 4. Connect the negative battery cable.

  5. After installing the front impact sensor, check that the system operates correctly:

    • Turn the ignition on. The SRS indicator should illuminate for approximately six seconds, then turn off.

Test yourself

A quick Kia Stinger CK quiz: every answer comes with an explanation and a link to the manual page.