Kia Cee'd Quiz
Body Electrical System

Hazard Warning Switch Repair Procedures

In this manual: Body Electrical System
General Information — 15Maintenance — 7Engine Mechanical System — 84Engine Electrical System — 49Emission Control System — 22Fuel System — 95Clutch System — 28Manual Transmission — 21Dual Clutch Transmission (DCT) System — 47Drive Shaft and Axle — 20Suspension System — 36Steering — 23Restraints — 39Brake System — 54Body (Interior and Exterior) — 209Body Electrical System — 254Heating, Ventilation, and Air Conditioning — 56
9steps
~54min
2/5difficulty
Done 0 of 9

Inspection

  1. The GDS can quickly diagnose hazard switch defects. The GDS can forcibly operate the actuator, monitor input/output values and perform self-diagnosis.
  2. Select the model and "BCM".
  3. Select "SJB" for inspection.
  4. Select "Current Data" to check the current data of the hazard switch. It shows the SJB input/output status.

Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the center air vent. (Refer to Body - "Instrument Panel")
  3. Remove the hazard warning switch (A) by disconnecting the clip from the center air vent.

Installation

  1. Install the hazard warning switch to the center air vent.
  2. Install the center air vent.

Test yourself

A quick Kia Cee'd quiz: every answer comes with an explanation and a link to the manual page.