Kia Cee'd Quiz
Body Electrical System

Rear Fog Lamp Repair Procedures

In this manual: Body Electrical System
General Information — 15Maintenance — 7Engine Mechanical System — 84Engine Electrical System — 49Emission Control System — 22Fuel System — 95Clutch System — 28Manual Transmission — 21Dual Clutch Transmission (DCT) System — 47Drive Shaft and Axle — 20Suspension System — 36Steering — 23Restraints — 39Brake System — 54Body (Interior and Exterior) — 209Body Electrical System — 254Heating, Ventilation, and Air Conditioning — 56
11steps
~66min
3/5difficulty
Done 0 of 11

Inspection

  1. Disconnect the negative (-) battery terminal.
  2. Remove the lighting switch from the multifunction switch. (Refer to Multifunction Switch)
  3. Using the front fog lamp switch, check for continuity between the terminals below. If the continuity does not match the specification, replace the multifunction switch.
    Fog Lamp

Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the rear bumper cover. (Refer to Body - Rear Bumper Cover)
  3. Disconnect the rear bumper main connector (A).
  4. Disconnect the rear fog lamp connector (A) and the ultrasonic sensor connector (B).
    Separate the wire harness clip (A) from the rear fog lamp assembly.
  5. Remove the bulb (A) by turning it counterclockwise.
  6. Remove the rear fog lamp (A) after loosening the mounting screws.

Installation

  1. Install the rear fog lamp and connect the connector.
  2. Install the rear bumper cover.

Test yourself

A quick Kia Cee'd quiz: every answer comes with an explanation and a link to the manual page.