Kia Cee'd Quiz
Body Electrical System

Rear Combination Lamp Repair Procedures

In this manual: Body Electrical System
General Information — 15Maintenance — 7Engine Mechanical System — 84Engine Electrical System — 49Emission Control System — 22Fuel System — 95Clutch System — 28Manual Transmission — 21Dual Clutch Transmission (DCT) System — 47Drive Shaft and Axle — 20Suspension System — 36Steering — 23Restraints — 39Brake System — 54Body (Interior and Exterior) — 209Body Electrical System — 254Heating, Ventilation, and Air Conditioning — 56
17steps
~102min
4/5difficulty
Done 0 of 17

Removal

[5 Door]

Rear Combination Lamp (Inside)

  1. Disconnect the negative (-) battery terminal.
  2. Remove the rear combination lamp cover (A).
  3. Remove the mounting nuts (4 pcs.) and disconnect the connector (A).
  4. Remove the rear combination lamp (A).
  5. Remove the rear combination lamp (A).
  6. Disconnect the negative (-) battery terminal.
  7. Remove the rear combination lamp assembly (A) after removing the bolts and disconnecting the connector (B).
  8. Replace the turn signal lamp bulb (A) by turning it counterclockwise.
  9. Disconnect the negative (-) battery terminal.
  10. Remove the rear combination lamp assembly (A) after loosening the screws.
  11. Disconnect the rear combination lamp connector (A).
  12. Replace the turn signal lamp bulb (A) and the stop lamp bulb (B) by turning them counterclockwise.
Rear combination lamp (outside) [3-door]

Installation

[5 Door]

  1. Install the rear combination lamp assembly (inside).
  2. Install the rear combination lamp assembly (outside).
  3. Connect the negative (-) battery terminal.

[3-Door]

  1. Install the rear combination lamp assembly.
  2. Connect the negative (-) battery terminal.

Test yourself

A quick Kia Cee'd quiz: every answer comes with an explanation and a link to the manual page.