Kia Picanto JA Quiz
Body Electrical System

Rear View Camera System

In this manual: Body Electrical System
General Information — 8Maintenance — 30Engine Mechanical System — 46Engine Electrical System — 14Emission Control System — 11Engine Control System/Fuel System — 46Clutch System — 12Manual Transmission — 10Drive Shaft and Axle — 8Suspension System — 15Steering — 9Restraints — 17Brake System — 22Body (Interior and Exterior) — 104Body Electrical System — 80Heating, Ventilation, and Air Conditioning — 17
15steps
~90min
4/5difficulty
Done 0 of 15

Components and Component Location

Component Location

1. Rear View Camera
2. AVN Head Unit		 3. Steering Wheel Angle Sensor

Description and Operation

Description

  1. To display the area behind the vehicle to assist the driver, the system receives the rear view image signal from the rear view camera and displays it on the AVN head unit monitor or the inside rear view mirror.
  2. The rear view camera is an optional device that displays the blind spot on the monitor screen. It operates automatically when the transmission remains in the "R" position for more than 3 seconds.
  3. The system displays the predicted path with parking guidelines according to the steering wheel angle. (No separate control unit.)
System Components (Rear View Camera, Steering Angle Sensor)

Circuit Diagrams

Wiring Diagram

Repair Procedures

Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the rear door trim panel. (Refer to Body - "Rear Door Trim")
  3. Disconnect the luggage compartment door outside handle connector (A).
  4. Remove the rear door outside handle assembly (A) after loosening the mounting nuts.
  5. Disconnect the connector of the tailgate open switch (A).
  6. Remove the rear view camera unit (A) after loosening the mounting screws.

Installation

  1. Install the rear view camera unit.
  2. Connect the luggage compartment door opening switch connector.
  3. Install the rear door outside handle assembly.
  4. Connect the luggage compartment door outside handle assembly connector.
  5. Install the liftgate trim.
  6. Connect the negative (-) battery terminal.

Test yourself

A quick Kia Picanto JA quiz: every answer comes with an explanation and a link to the manual page.