Kia Picanto JA Quiz
Body Electrical System

Ignition Lock Assembly

In this manual: Body Electrical System
General Information — 8Maintenance — 30Engine Mechanical System — 46Engine Electrical System — 14Emission Control System — 11Engine Control System/Fuel System — 46Clutch System — 12Manual Transmission — 10Drive Shaft and Axle — 8Suspension System — 15Steering — 9Restraints — 17Brake System — 22Body (Interior and Exterior) — 104Body Electrical System — 80Heating, Ventilation, and Air Conditioning — 17
19steps
~114min
4/5difficulty
Done 0 of 19

Repair Procedures

Inspection

  1. Disconnect the key warning switch connector (A) and the ignition lock connector (B) from the steering column.
  2. Check the circuit between the terminals for continuity.
  3. If continuity is not as specified, replace the switch.

Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the emergency pad lower panel. (Refer to Body - "Emergency Pad Lower Panel")
  3. Remove the upper and lower steering column covers. (Refer to Body - "Steering Column Shroud Panel")
  4. Remove the combination switch. (Refer to Body Electrical System - "Combination Switch")
  5. Disconnect the ignition switch connector (A) and the key warning/immobilizer connector (B).
  6. Insert the key and turn it to the ACC position.
  7. Press the stopper pin (B) with an awl.
  8. Remove the key cylinder with key (A).

    C: Key warning / immobilizer connector D: Ignition lock connector

  9. Remove the ignition lock (A) after loosening the mounting bolts.

Installation

  1. Install the ignition lock.
  2. Install the key cylinder lock.
  3. Connect the ignition switch connector and the key warning/immobilizer connector.
  4. Install the multifunction switch.
  5. Install the upper and lower steering column covers.
  6. Install the emergency pad lower panel.
  7. Connect the negative (-) battery terminal.

Test yourself

A quick Kia Picanto JA quiz: every answer comes with an explanation and a link to the manual page.