Brake Line

Components and Component Location

Components

Repair Procedures

Removal

1. 1
   Disconnect the brake fluid level sensor connector.

   

2. 2
   Remove the brake fluid from the master cylinder reservoir using a syringe.
3. 3
   Remove the front/rear wheel tire (A).

   Tightening torque: 107.9–128 N·m

   [Front]

   

   [Rear]

   

4. 4
   Disconnect the brake tube by loosening the tube flare nut (A).
5. 5
   Remove the brake hose clamp (B).

   Tightening torque: 12.7 - 16.7 N·m

   

6. 6
   Disconnect the brake tube by loosening the tube flare nut (A).
7. 7
   Remove the brake hose clamp (B).

   Tightening torque: 12.7 - 16.7 N·m

   

8. 8
   Disconnect the brake hose from the brake caliper by loosening the bolt (A).

   Tightening Torque: 24.5–29 N·m

   [Front]

   

   [Rear]

   

Inspection

1. 1
   Inspect the brake tubes for cracks, bends and corrosion.
2. 2
   Inspect the brake hoses for cracks, damage and fluid leaks.
3. 3
   Inspect the tube flare nuts for damage and fluid leaks.
4. 4
   Inspect the brake hose mounting bracket for cracks or deformation.

Installation

1. 1
   Install in the reverse order of removal.
2. 2
   After installation, bleed the brake system. (Refer to Brake System — "Brake System")
3. 3
   Inspect for spilled brake fluid.