Kia Picanto JA Quiz
Clutch System

Clutch Master Cylinder

In this manual: Clutch System
General Information — 8Maintenance — 30Engine Mechanical System — 46Engine Electrical System — 14Emission Control System — 11Engine Control System/Fuel System — 46Clutch System — 12Manual Transmission — 10Drive Shaft and Axle — 8Suspension System — 15Steering — 9Restraints — 17Brake System — 22Body (Interior and Exterior) — 104Body Electrical System — 80Heating, Ventilation, and Air Conditioning — 17
10steps
~60min
3/5difficulty
Done 0 of 10

Components and Component Location

Components

[Kappa 1.0 T-GDI]
1. Clutch pedal assembly
2. Ignition lock and clutch switch
3. Clutch master cylinder		 4. Clutch adjuster
5. Clutch tube

Repair Procedures

Removal

  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  2. Remove the emergency pad lower panel. (Refer to Body - "Emergency Pad Lower Panel")
  3. Disconnect the connector of the ignition lock and clutch switch.
  4. Remove the push rod end (A) from the clutch pedal.
  5. Remove the battery. G 1.0 T-GDI KAPPA (See Engine Electrical System - Battery)
  6. Remove the ECM. G 1.0 T-GDI KAPPA (See Engine Control/Fuel System - Engine Control Module (ECM))
  7. After removing the pin (C), disconnect the reservoir hose (A) and the clutch tube (B) from the clutch master cylinder.
  8. Remove the clutch master cylinder (A) by turning it clockwise.

Installation

  1. Install in the reverse order of removal.
  2. After installation, perform the air bleeding procedure for the clutch release cylinder after filling with brake fluid. (Refer to Clutch Release Cylinder - "Adjustment")

Test yourself

A quick Kia Picanto JA quiz: every answer comes with an explanation and a link to the manual page.