Kia Picanto JA Quiz
Clutch System

Clutch Tube

In this manual: Clutch System
General Information — 8Maintenance — 30Engine Mechanical System — 46Engine Electrical System — 14Emission Control System — 11Engine Control System/Fuel System — 46Clutch System — 12Manual Transmission — 10Drive Shaft and Axle — 8Suspension System — 15Steering — 9Restraints — 17Brake System — 22Body (Interior and Exterior) — 104Body Electrical System — 80Heating, Ventilation, and Air Conditioning — 17
8steps
~48min
2/5difficulty
0102030405014.711N·mlb·ft
Tightening torque found on this page
Done 0 of 8

Components and Component Location

Components

[Kappa 1.0 T-GDI]
1. Clutch pedal assembly
2. Ignition lock and clutch switch
3. Clutch master cylinder		 4. Clutch adjuster
5. Clutch tube

Repair Procedures

Removal

  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  2. Remove the battery and battery tray. G 1.0 T-GDI KAPPA (Refer to Engine Electrical System - "Battery")
  3. Remove the ECM. G 1.0 T-GDI KAPPA (See Engine Control/Fuel System - Engine Control Module (ECM))
  4. Remove the engine room cover. G 1.0 T-GDI KAPPA (Refer to Engine Mechanical System - "Engine Room Cover")
  5. Loosen the clutch tube bracket bolts (B), then remove the stopper pin (A) from the regulator.

    Tightening torque: 9.8–14.7 N·m

  6. Loosen the release cylinder bolts (A), then the clutch tube nut (B) after removing the release cylinder assembly (C).

    Tightening torque: 14.7 ~ 22 N·m

Installation

  1. Install in the reverse order of removal.
  2. After installation, perform the air bleeding procedure after filling with brake fluid. (Refer to Clutch Release Cylinder - "Adjustment")

Test yourself

A quick Kia Picanto JA quiz: every answer comes with an explanation and a link to the manual page.