Kia Picanto JA Quiz
Body (Interior and Exterior)

Rear Seat Back Cover

In this manual: Body (Interior and Exterior)
General Information — 8Maintenance — 30Engine Mechanical System — 46Engine Electrical System — 14Emission Control System — 11Engine Control System/Fuel System — 46Clutch System — 12Manual Transmission — 10Drive Shaft and Axle — 8Suspension System — 15Steering — 9Restraints — 17Brake System — 22Body (Interior and Exterior) — 104Body Electrical System — 80Heating, Ventilation, and Air Conditioning — 17
29steps
~174min
5/5difficulty
Done 0 of 29

Components and Component Location

Component Location

1. Rear Seatback Cover [RH] 2. Rear Seatback Cover [LH]

Repair Procedures

Replacement

[LH]
  1. Remove the rear seat assembly. (Refer to Rear Seat - "Rear Seat Assembly")
  2. Press the stopper pin and remove the rear seat headrest (A).
  3. Remove the upper face panel cover (A) using a trim removal tool.
  4. Remove the rear seatback belt guide (A) using a trim removal tool.
  5. Remove the child anchor cover (A) using a removal tool.
  6. Remove the rear seatback dust cover (A).
  7. Remove the ring clips from the rear seat lower mounting (A).
  8. Open the side zipper of the seatback (A). [Left]
    [LH]
  9. Disconnect the mounting hook (A) of the rear seatback trim.
  10. Remove the rear panel (A) after removing the clips.
  11. Disconnect the side mounting hook (A) of the rear seatback trim.
  12. Press the rear headrest guides (A) while squeezing both sides of the lower part of the guides, then remove them.
  13. Remove the rear seatback trim from the frame.
  14. Remove the front seatback trim (C) after removing the hook-and-loop fastener (A) and clip (B).
  15. Install in the reverse order of removal.
  16. Remove the rear seat assembly. (Refer to Rear Seat - "Rear Seat Assembly")
  17. Press the stopper pin and remove the rear seat headrest (A).
  18. Remove the upper face panel cover (A) using a trim removal tool.
  19. Remove the child anchor cover (A) using a removal tool.
  20. Remove the rear seatback dust cover (A).
  21. Remove the ring clips from the rear seat lower mounting (A).
  22. Open the side zipper of the seatback (A). [Left]
    [LH]
  23. Disconnect the mounting hook (A) of the rear seatback trim.
  24. Remove the rear panel (A) after removing the clips.
  25. Disconnect the side mounting hook (A) of the rear seatback trim.
  26. Press the rear headrest guides (A) while squeezing both sides of the lower part of the guides, then remove them.
  27. Remove the rear seatback trim from the frame.
  28. Remove the front seatback trim (C) after removing the hook-and-loop fastener (A) and clip (B).
  29. Install in the reverse order of removal.
[RH]

Test yourself

A quick Kia Picanto JA quiz: every answer comes with an explanation and a link to the manual page.