Kia Rio YB Quiz
Body Electrical System

Rear View Camera System

In this manual: Body Electrical System
General Information — 8Maintenance — 31Engine Mechanical System — 44Engine Electrical System — 14Emission Control System — 9Engine Control System/Fuel System — 30Clutch System — 10Manual Transmission — 10Automatic Transmission — 23Drive Shaft and Axle — 8Suspension System — 15Steering — 9Restraints — 14Brake System — 22Body (Interior and Exterior) — 115Body Electrical System — 84Heating, Ventilation, and Air Conditioning — 28
15steps
~90min
4/5difficulty
Done 0 of 15

Components and Component Location

Component Location

1. Rear View Camera
2. AVN Head Unit		 3. Steering Wheel Angle Sensor

Description and Operation

Description

  1. To display the area behind the vehicle to assist the driver, it receives the rear image signal from the rear view camera and displays it on the AVN head unit monitor or the inside rear view mirror.

  2. The rear view camera is an optional device that displays the blind spot on the monitor screen. It operates automatically when the transmission remains in the "R" position for more than 3 seconds.

  3. It displays the predicted trajectory with parking guide lines according to the steering wheel operating angle. (There is no separate control unit.)

System Structure (Rear View Camera Controlled by Steering)

Circuit Diagrams

Wiring Diagram

Repair Procedures

Removal

  1. Disconnect the negative (-) battery terminal.

  2. Remove the liftgate garnish.

    (Refer to Body - "Rear Door Trim")

  3. Disconnect the luggage compartment door outside handle connector (A).

  4. Remove the luggage door outside handle assembly (A) after loosening the nuts.

  5. Disconnect the rear view camera assembly connector (A).

  6. Remove the rear view camera assembly (B) after loosening the mounting screws.

Installation

  1. Connect the rear view camera assembly connector.

  2. Install the rear view camera unit.

  3. Install the rear door outside handle assembly.

  4. Connect the luggage compartment door outside handle assembly connector.

  5. Install the liftgate trim.

  6. Connect the negative (-) battery terminal.

Test yourself

A quick Kia Rio YB quiz: every answer comes with an explanation and a link to the manual page.