Kia Rio YB Quiz
Body Electrical System

Ignition Switch

In this manual: Body Electrical System
General Information — 8Maintenance — 31Engine Mechanical System — 44Engine Electrical System — 14Emission Control System — 9Engine Control System/Fuel System — 30Clutch System — 10Manual Transmission — 10Automatic Transmission — 23Drive Shaft and Axle — 8Suspension System — 15Steering — 9Restraints — 14Brake System — 22Body (Interior and Exterior) — 115Body Electrical System — 84Heating, Ventilation, and Air Conditioning — 28
19steps
~114min
4/5difficulty
Done 0 of 19

Repair Procedures

Inspection

  1. Disconnect the key warning switch connector (A) and the ignition lock connector (B) from the steering column.

  2. Check the circuit between the terminals for continuity.

  3. If continuity is not as specified, replace the switch.

Removal

  1. Disconnect the negative (-) battery terminal.

  2. Remove the airbag lower panel.

    (Refer to Body - "Under Cover Panel")

  3. Remove the upper and lower steering column covers.

    (Refer to Body - "Steering Column Shroud Panel")

  4. Remove the multifunction switch.

    (Refer to Body Electrical System - "Multifunction Switch")

  5. Remove the ignition lock connector (A) and the key warning/immobilizer connector (B).

  6. Insert the key and turn it to the ACC position.

  7. Press the stopper pin (A) out using an awl.

  8. Remove the key cylinder with key (A).

    B: Key Warning Switch C: Ignition Lock Connector

  9. Remove the ignition lock (A) after loosening the mounting bolts.

Installation

  1. Install the ignition lock.

  2. Install the key cylinder lock.

  3. Connect the ignition switch connector and the key warning/immobilizer connector.

  4. Install the multifunction switch.

  5. Install the upper and lower steering column covers.

  6. Install the emergency pad lower panel.

  7. Connect the negative (-) battery terminal.

Test yourself

A quick Kia Rio YB quiz: every answer comes with an explanation and a link to the manual page.