Front Door

Components and Component Location

Components

Repair Procedures

Adjustment

Window Adjustment

1. 1

   Remove the front door trim panel.

   (Refer to Front Door - Front Door Trim Panel)

2. 2

   Loosen the screws, then remove the door handle bracket (A).

   

3. 3

   Disconnect the front door speaker connector (A), then remove the wiring clips.

   

4. 4

   Remove the front door trim cover seal (A).

   

5. 5

   Carefully slide the front door glass (A) until the glass mounting bolts are visible, then loosen them.

   

6. 6

   Make sure the glass moves smoothly.

Door Latch Adjustment

1. 1

   Loosen the screws (B) just enough to allow the latch to move.

   Tightening torque: (B): 16.7–22 N·m

   

2. 2

   Tap the striker with a plastic hammer to adjust it. The striker will not move much, but will allow some adjustment.

3. 3

   While holding the outside handle, press the door against the body to make sure the striker allows a flush fit. If the door latches correctly, tighten the screws and recheck.

Door Position Adjustment

1. 1

   Make sure the door and body edges are parallel.

   

2. 2

   When adjusting the doors, place the vehicle on a hard, level surface.

3. 3

   Adjust at the hinges (A):

   • Slightly loosen the door mounting bolts and move the door inward and outward until it is flush with the body.

   • Slightly loosen the hinge mounting bolts and move the door rearward and forward or up and down as necessary to align the gaps.

   • Place a shop towel on the jack to avoid damaging the door when adjusting the door.

   Tightening torque: (B): 21.6–26 N·m

   

4. 4

   Lubricate the moving parts of the specified hinges.

5. 5

   Check for water leaks.