Kia Rio YB Quiz
Restraints

PAB ON/OFF Switch

In this manual: Restraints
General Information — 8Maintenance — 31Engine Mechanical System — 44Engine Electrical System — 14Emission Control System — 9Engine Control System/Fuel System — 30Clutch System — 10Manual Transmission — 10Automatic Transmission — 23Drive Shaft and Axle — 8Suspension System — 15Steering — 9Restraints — 14Brake System — 22Body (Interior and Exterior) — 115Body Electrical System — 84Heating, Ventilation, and Air Conditioning — 28
11steps
~66min
3/5difficulty
Done 0 of 11

Description and Operation

Description

The driver can control the passenger airbag deployment status (enable or disable) using this PAB ON/OFF switch.

The Passenger Airbag (PAB) ON/OFF switch is installed in the side cover of the instrument panel.

Components and Component Location

Components

Repair Procedures

Removal

  1. Remove the ignition key from the vehicle.

  2. Disconnect the negative battery cable and wait at least three minutes before starting work.

  3. Remove the side cover of the airbag (A).

  4. Disconnect the PAB ON/OFF switch connector (A).

  5. Remove the PAB ON/OFF switch.

Installation

  1. Remove the ignition key from the vehicle.

  2. Disconnect the negative battery cable and wait at least three minutes before starting work.

  3. Install the PAB ON/OFF switch on the side airbag cover.

  4. Connect the PAB ON/OFF switch connector.

  5. Install the side cover of the airbag.

    (Refer to Body - Airbag Side Cover)

  6. After installing the SRSCM, check that the system operates correctly:

    • Turn the ignition ON; the SRS indicator should illuminate for about six seconds, then go off.

Test yourself

A quick Kia Rio YB quiz: every answer comes with an explanation and a link to the manual page.