Kia Rio YB Quiz
Drive Shaft and Axle

Rear Hub — Carrier

In this manual: Drive Shaft and Axle
General Information — 8Maintenance — 31Engine Mechanical System — 44Engine Electrical System — 14Emission Control System — 9Engine Control System/Fuel System — 30Clutch System — 10Manual Transmission — 10Automatic Transmission — 23Drive Shaft and Axle — 8Suspension System — 15Steering — 9Restraints — 14Brake System — 22Body (Interior and Exterior) — 115Body Electrical System — 84Heating, Ventilation, and Air Conditioning — 28
15steps
~90min
4/5difficulty
04080120160200127.594N·mlb·ft
Tightening torque found on this page
Done 0 of 15

Components and Component Location

Components

[Drum Type]

1. Torsion Beam
2. Rear Spring		 3. Rear Drum Brake Disc

[Disc Type]

1. Torsion Beam
2. Rear Spring		 3. Rear Brake Disc

Repair Procedures

Removal

[Disc Type]

  1. Remove the wheel and tire.

    Tightening torque: 107.9–128 N·m

  2. Remove the brake caliper (A) and parking brake cable (B).

  3. Remove the rear brake caliper assembly (A).

    Tightening torque: 78.4–98 N·m

  4. Loosen the mounting screw and the brake disc (A).

    Tightening torque: 4.9 - 5.9 N·m

  5. Loosen the bolts and remove the hub (A) from the torsion beam axle.

    Tightening torque: 49.0–59 N·m

  6. Install in the reverse order of removal.

[Drum Type]

  1. Remove the wheel and tire.

    Tightening torque: 107.9–128 N·m

  2. Loosen the mounting screw and the brake disc (A).

    Tightening torque: 4.9 - 5.9 N·m

  3. Disconnect the wheel speed sensor.

  4. Loosen the hub mounting bolt and remove the hub (A) from the torsion beam.

    Tightening torque: 49.0–59 N·m

  5. Install in the reverse order of removal.

Inspection

  1. Check the hub for cracks and worn splines.

  2. Check the brake disc for scratches and damage.

  3. Inspect the rear axle beam for cracks.

  4. Check the bearing for cracks or damage.

Test yourself

A quick Kia Rio YB quiz: every answer comes with an explanation and a link to the manual page.