Kia Rio YB Quiz
Body (Interior and Exterior)

Rear Seat Belt Retractor

In this manual: Body (Interior and Exterior)
General Information — 8Maintenance — 31Engine Mechanical System — 44Engine Electrical System — 14Emission Control System — 9Engine Control System/Fuel System — 30Clutch System — 10Manual Transmission — 10Automatic Transmission — 23Drive Shaft and Axle — 8Suspension System — 15Steering — 9Restraints — 14Brake System — 22Body (Interior and Exterior) — 115Body Electrical System — 84Heating, Ventilation, and Air Conditioning — 28
14steps
~84min
4/5difficulty
02040608010053.940N·mlb·ft
Tightening torque found on this page
Done 0 of 14

Components and Component Location

Component Location

[5 Door]

1. Rear Seat Belt Pretensioner

[4 Door]

1. Rear Seat Belt Retractor [LH] 2. Rear Seat Belt Retractor [RH]

Repair Procedures

Replacement

[5 Door]

  1. Remove the rear pillar trim.

    (Refer to Interior Trim - "Rear Pillar Trim Panel")

  2. Remove the rear seat belt upper anchor (A) after loosening the mounting bolts.

    Torque: 39.2 – 54 N·m

  3. Disconnect the seat belt pretensioner connector (A).

  4. Remove the rear seat belt pretensioner (A) after loosening the mounting bolt.

    Torque: 39.2 – 54 N·m

  5. Install in the reverse order of removal.

[4 Door]

  1. Remove the rear seat assembly.

    (Refer to Rear Seat - "Rear Seat Assembly")

  2. Remove the rear pillar trim (A) using a trim removal tool.

  3. Remove the rear door sill trim.

  4. Remove the rear partition trim (A) by removing the mounting screw.

  5. Remove the rear wheel house trim (A) after removing the mounting screw.

  6. Remove the rear center seat belt cover (A).

  7. Remove the rear parcel shelf trim (A).

  8. Remove the rear seat belt pretensioner (A) after loosening the mounting bolt.

    Torque: 39.2 – 54 N·m

    [LH]

    [RH]

  9. Install in the reverse order of removal.

Test yourself

A quick Kia Rio YB quiz: every answer comes with an explanation and a link to the manual page.