Brakes

Calibration of Yaw Rate Sensor

10steps
~60min
4/5difficulty
Done 0 of 10

Description

×: Required —: Not required

ProcedureYaw rate sensor calibration
Removing/ installing ABS actuator and electric unit (control unit) ×
Replacing ABS actuator and electric unit (control unit) ×
Removing/installing steering components —
Replacing steering components —
Removing/installing front suspension components —
Replacing front suspension components —
Removing/installing tire —
Replacing tire —
Tire rotation —
Adjusting front wheel alignment. —

Work Procedure

CHECK THE VEHICLE STATUS

  1. Steer the steering wheel to the straight-ahead position. Stop the vehicle on level surface.

  2. Stop the engine.

  3. Ignition switch OFF (Auto ACC function OFF).

Is the vehicle stopped in the straight-ahead position on level surface?

YES>>

GO TO 2.

NO>>

Steer the steering wheel to the straight-ahead position. Stop the vehicle on level surface.

PERFORM YAW RATE SENSOR CALIBRATION

With CONSULT

  1. Ignition switch ON.

  2. Select “ABS”, “Work support”, “Yaw rate sensor calibration” in this order.

  3. Select “START”.

  4. After approximately 10 seconds, select “END”.

  5. Ignition switch OFF (Auto ACC function OFF) and then it ON again.

>>

GO TO 3.

CHECK DATA MONITOR

With CONSULT

  1. Drive the vehicle. Steer the steering wheel to the straight-ahead position. Stop the vehicle on level surface.

  2. Select “ABS”, “Data monitor”, and “Yaw rate sensor” in this order. Check that the signal is within the specified value. Refer to Reference Value.

Is the inspection result normal?

YES>>

GO TO 4.

NO>>

GO TO 1.

ERASE SELF-DIAGNOSIS MEMORY

With CONSULT

Erase self-diagnosis result of all systems.

Are the memories erased?

YES>>

INSPECTION END

NO>>

Check the items indicated by the self-diagnosis.