Brakes
Change of System Mode
In this manual: Brakes
6steps
~36min
3/5difficulty
Done 0 of 6
Description
×: Required —: not required
| Procedure | System mode change |
|---|---|
| Removing/installing ABS actuator and electric unit (control unit) | — |
| Replacing ABS actuator and electric unit (control unit) | × |
| Removing/installing rear brake pad (When not pressing piston of rear brake caliper assembly) | — |
| Replacing rear brake caliper assembly | — |
| Removing/installing parking brake switch | — |
| Replacing parking brake switch | — |
Work Procedure
Replacing ABS actuator and electric unit (control unit)
CHANGE OF SYSTEM MODE
With CONSULT
Select “ABS”, "Work support", and "System mode change" according to this order.
Touch “START”.
Check display item “Factory mode”.
Is the inspection result “Off”?
YES>>GO TO 2.
NO>>Perform change of system mode again.
PERFORM THE SELF-DIAGNOSIS
With CONSULT
Pull parking brake switch to activate electric parking brake.
Push parking brake switch to release electric parking brake.
Perform self-diagnosis for “ABS”.
Is malfunction detected?
YES>>Check the DTC. Refer to DTC Index.
NO>>INSPECTION END
Was this page helpful?