Excessive Operation Frequency
Description
VDC function, TCS function, ABS function, EBD function, brake limited slip differential (BLSD) function, brake assist function, hill start assist function, advanced hill descent control function (4WD models) and trailer sway control function operates in excessive operation frequency.
Diagnosis Procedure
CHECK BRAKING FORCE
Check brake force using a brake tester.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Check the brake system.
CHECK FRONT AXLE AND REAR AXLE
Disconnect 12V battery negative terminal.
Check that there is no excessive looseness in front and rear axle.
Front axle
2WD models: Refer to Inspection.
4WD models: Refer to Inspection.
Rear axle: Refer to Inspection.
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair or replace error-detected parts.
CHECK WHEEL SENSOR
Check the wheel sensor.
Check installation and damage of wheel sensor.
Check connection of wheel sensor harness connector.
Check terminal of wheel sensor harness connector.
Is the inspection result normal?
YES>>GO TO 4.
NO>>Repair or replace the wheel sensor.
Front wheel sensor: Refer to Removal and Installation.
Rear wheel sensor: Refer to Removal and Installation.
CHECK SENSOR ROTOR
Check that there is no looseness, damage or foreign material on sensor rotor.
Is the inspection result normal?
YES>>GO TO 5.
NO>>Repair or replace the sensor rotor.
Front sensor rotor
2WD models: Refer to Removal and Installation.
4WD models: Refer to Removal and Installation.
Rear sensor rotor: Refer to Removal and Installation.
CHECK WARNING LAMP TURN OFF
Connect 12V battery negative terminal.
Check that VDC warning lamp and ABS warning lamp turn OFF several seconds after ignition switch is ON.
Check that VDC warning lamp and ABS warning lamp turn OFF after engine started or driving.
Is the inspection result normal?
YES>>Normal
NO>>Perform self-diagnosis for “ABS” with CONSULT.