Body Exterior, Doors, Roof & Vehicle Security

Off Road Models

~6min read

Exploded View

Front bumper side bracket RH Front bumper side retainer RH Front bumper retainer upper
Front bumper side stay RH Front bumper reinforcement Front bumper energy absorber A
Front bumper energy absorber B RH Front bumper energy absorber C RH Front bumper energy absorber D
Front bumper energy absorber C LH Front bumper finisher Front bumper fascia
U nut Front bumper side bracket LH Front bumper side retainer LH
Front bumper side stay LH Front bumper energy absorber B LH Front bumper side finisher RH
License plate bracket Front bumper side finisher LH

Front bumper protector

(if equipped)

Double-sided tape

[t: 0.8 mm (0.031 in)]

(if equipped)

Double-sided tape

[t: 1.2 mm (0.047 in)]

(if equipped)

Retainer

(if equipped)

Grommet

(if equipped)
Clip
: Clip
: Pawl
: Always replace after every disassembly.
, , , , , : Indicates that the part is connected at points with same symbol in actual vehicle.

Removal and Installation

REMOVAL

Remove front grille. Refer to Removal and Installation.

Remove fillet molding (with fillet molding). Refer to Removal and Installation.

Remove front bumper energy absorber A.

Disengage active grille shutter fixing clips .

Disengage fixing clips and pawls, and then remove front bumper side finisher (LH and RH).

: Clip
: Pawl

Remove front bumper fascia fixing clips .

Remove fixing bolts .

Remove fixing bolts .

Remove fixing screws .

Apply protective tapes (A) on the part to protect it from damage.

Pull front bumper fascia assembly side toward the vehicle side to disengage the fitting of front bumper side bracket and front bumper fascia assembly side according to the numerical order 1→2 as shown by the arrows in the figure.

: Pawl

Disconnect front sonar sensor harness connector.

Remove front bumper fascia assembly.

Remove the following parts after removing front bumper fascia assembly.

  • Front sonar sensor. Refer to SONAR SENSOR (FRONT) : Removal & Installation.

  • License plate bracket

  • Front bumper protector (if equipped)

  • U nuts

  • Front bumper finisher

  • Grommets (if equipped)

Remove mounting nuts, and then remove front bumper retainer upper.

Remove mounting bolts, and then remove front bumper side retainer (LH and RH).

Remove active grille shutter fixing clip and mounting nuts. Refer to Exploded View.

Remove mounting nuts, and then remove front bumper reinforcement.

Remove mounting bolts, and then remove front bumper side stay (LH and RH).

Remove front bumper energy absorber B (LH and RH).

Remove front bumper energy absorber C (LH and RH).

Disengage fixing pawls, and then remove front bumper energy absorber D.

Remove front bumper side bracket (LH and RH) fixing screws.

Disengage fixing pawls, and then remove front bumper side bracket (LH and RH).

INSTALLATION

Note the following items, and then install in the reverse order of removal.