Driver Information & Multimedia

B130d Tel Line Out Error

11steps
~66min
3/5difficulty
Done 0 of 11
DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
B130D

TEL LINE OUT ERROR

(Telephone line out error)
Diagnosis condition When ignition switch is ON.
Signal (terminal) Sound signal between TCU and AV control unit (terminals 31 and 32)
Threshold —
Diagnosis delay time 1 second or more

POSSIBLE CAUSE

  • Sound signal circuits between TCU and AV control unit

  • TCU

  • AV control unit

FAIL-SAFE

Telematics system function stops

DTC Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON.

  2. Erase DTC.

  3. Select “Self Diagnostic Result” mode of ”TELEMATICS”.

  4. Check DTC.

Is DTC U130D detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

Diagnosis Procedure

CHECK CONTINUITY BETWEEN TCU AND AV CONTROL UNIT CIRCUIT

  1. Ignition switch OFF.

  2. Disconnect TCU connector and AV control unit connector.

  3. Check continuity between TCU connector and AV control unit connector.

    TCU AV control unit Continuity
    Connector Terminal Connector Terminal
    M126 31 M162 32 Yes
    32 52
  4. Check continuity between TCU connector and ground.

    TCU Ground Continuity
    Connector Terminal
    M126 31 No
    32

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair or replace harness or connectors.

CHECK SOUND SIGNAL

  1. Connect TCU connector and AV control unit connector.

  2. Ignition switch ON.

  3. Check signal between the terminals of TCU connector.

    TCU Condition Reference value
    Connector (+) (−)
    Terminal
    M126 31 32 When interior sound is input

Is the inspection result normal?

YES>>

Replace TCU. Refer to Removal and Installation.

NO>>

Replace AV control unit. Refer to Removal and Installation.