Driver Information & Multimedia
U1a04 Vin Unfinished
In this manual: Driver Information & Multimedia
4steps
~24min
2/5difficulty
Done 0 of 4
DTC DETECTION LOGIC
| DTC No. | CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | |
|---|---|---|---|
| U1A04 | VIN UNFINISHED (VIN unfinished) |
Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | — | ||
| Threshold | Nissan Murano Vehicle identification number is not written | ||
| Diagnosis delay time | 1 second or more | ||
POSSIBLE CAUSE
VIN number is not written
TCU
FAIL-SAFE
Telematics system does not function
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
Ignition switch ON.
Erase DTC.
Select “Self Diagnostic Result” mode of “TELEMATICS”.
Check DTC.
Is DTC U1A04 detected?
YES>>Proceed to DTC Diagnosis Procedure.
NO>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>Confirmation after repair: Inspection End.
PERFORM WRITING VIN DATA TO TCU
Perform writing VIN data to TCU. Refer to Description.
Was the writing of VIN data completed?
YES>>GO TO 2.
NO>>Replace TCU. Refer to Removal and Installation.
PERFORM DTC CONFIRMATION PROCEDURE AGAIN
Perform DTC confirmation procedure again. Refer to DTC Description.
Is DTC U1A04 detected again?
YES>>Replace TCU. Refer to Removal and Installation.
NO>>Inspection End.
Was this page helpful?