Driver Information & Multimedia

B2e33 Ecall Button

9steps
~54min
2/5difficulty
Done 0 of 9
DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
B2E33

ECALL BUTTON

(Ecall button)
Diagnosis condition When ignition switch is ON.
Signal (terminal) SOS switch LED signal (terminal 5)
Threshold —
Diagnosis delay time 1 second or more

POSSIBLE CAUSE

  • SOS switch LED signal circuit

  • SOS switch

  • TCU

FAIL-SAFE

  • Telematics system does not function (Only SOS call does not operate)

  • SOS switch LED indicator is turned OFF

DTC Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON.

  2. Erase DTC.

  3. Select “Self Diagnostic Result” mode of “TELEMATICS”.

  4. Check DTC.

Is DTC B2E33 detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

Diagnosis Procedure

CHECK SOS SWITCH LED SIGNAL

  1. Ignition switch ON.

  2. Check the voltage between TCU connector and ground.

    TCUGround

    Voltage

    (Approx.)
    ConnectorTerminal
    M126 5 –— 3.5 V

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Replace TCU. Refer to Removal and Installation.

CHECK SOS SWITCH LED SIGNAL CIRCUIT FOR OPEN

  1. Ignition switch OFF.

  2. Disconnect TCU connector and telematics switch connector.

  3. Check the continuity between TCU connector and telematics switch connector.

    TCUTelematics switchContinuity
    ConnectorTerminalConnectorTerminal
    M126 5 R21 2 Yes

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace harness or connectors.

CHECK SOS SWITCH LED SIGNAL CIRCUIT FOR SHORT

Check the continuity between TCU connector and ground.

TCU Ground Continuity
Connector Terminal
M126 5 Yes

Is the inspection result normal?

YES>>

Replace telematics switch. Refer to Removal and Installation.

NO>>

Repair or replace harness or connectors.