Driver Information & Multimedia

U1a05 Usb Comm

7steps
~42min
2/5difficulty
Done 0 of 7
DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
U1A05

USB COMM

(USB comm)
Diagnosis condition When ignition switch is ON.
Signal (terminal) —
Threshold Malfunction in USB communication between TCU and AV control unit
Diagnosis delay time —

POSSIBLE CAUSE

  • USB harness

  • TCU

FAIL-SAFE

—

DTC Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON.

  2. Select “Self Diagnostic Result” mode of “TELEMATICS”.

  3. Check DTC.

Is DTC U1A05 detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

Diagnosis Procedure

CHECK USB CIRCUITS CONTINUITY

  1. Ignition switch OFF.

  2. Disconnect TCU connector and AV control unit connector.

  3. Check continuity between TCU connector and AV control unit connector.

    TCUAV control unitContinuity
    ConnectorTerminalConnectorTerminal
    M127 41 M169 76 Yes
    43 78
    44 79
    45 80
    46 81
  4. Check the continuity between TCU connector and ground.

    TCU Ground Continuity
    Connector Terminal
    M127 41 — No
    44

Is the inspection result normal?

YES>>

Replace TCU. Refer to Removal and Installation.

NO>>

Repair or replace harness or connectors.