Driver Information & Multimedia
Power Supply and Ground Circuit
In this manual: Driver Information & Multimedia
5steps
~30min
2/5difficulty
Done 0 of 5
CHECK FUSE
Check that the following fuses are not blown:
| Terminal No. | Signal name | Fuse No. | Capacity |
|---|---|---|---|
| 1 | Battery power supply | 25 | 10 A |
| 2 | ACC power supply | 7 | 10 A |
| 10 | Ignition signal | 29 | 10 A |
Are the fuses blown?
YES>>Replace the blown fuse after repairing the affected circuit.
NO>>GO TO 2.
CHECK POWER SUPPLY CIRCUIT
Ignition switch OFF.
Disconnect TCU connector.
Check voltage between TCU connector and ground.
TCU Ground Condition Voltage
(Approx.)Connector Terminal M126 1 — Ignition switch: OFF Battery voltage 2 Ignition switch: ACC 10 Ignition switch: ON
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair or replace harness or connectors.
CHECK GROUND CIRCUIT
Ignition switch OFF.
Check continuity between TCU connector and ground.
TCU Ground Continuity Connector Terminal M126 28 — Yes 29
Is the inspection result normal?
YES>>Inspection End.
NO>>Repair or replace harness or connectors.
Was this page helpful?