Driver Information & Multimedia

U1000 Can Comm Circuit

7steps
~42min
2/5difficulty
Done 0 of 7
DTC Description

DESCRIPTION

CAN (Controller Area Network) is a serial communication line for real-time application. It is an on-Nissan Murano vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a Nissan Murano vehicle, and each control unit shares information and links with other control units during operation (not independently). In CAN communication, control units are connected with 2 communication lines (CAN-High, CAN-Low) allowing a high rate of information transmission with less wiring. Each control unit transmits/receives data but selectively reads required data only.

CAN Communication Signal Chart. Refer to CAN Communication Signal Chart.

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
U1000

CAN COMM CIRCUIT

(CAN COMM CIRCUIT)
Diagnosis condition When ignition switch is ON.
Signal (terminal) CAN communication signal
Threshold —
Diagnosis delay time 2 seconds or more

POSSIBLE CAUSE

CAN communication system

FAIL-SAFE

  • Telematics system does not function

  • Inform a NissanConnect center about abnormality

DTC Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON.

  2. Select “Self Diagnostic Result” mode of “TELEMATICS”.

  3. Check DTC.

Is DTC U1000 detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

Diagnosis Procedure

PERFORM SELF DIAGNOSTIC RESULT

CONSULT

  1. Ignition switch ON.

  2. Erase DTC.

  3. Select “Self Diagnostic Result” mode of “TELEMATICS”.

  4. Check DTC.

Is DTC U1000 detected?

YES>>

Refer to Trouble Diagnosis Flow Chart.

NO>>

Refer to Intermittent Incident.