Body Interior

B2128 Uart Comm

11steps
~66min
3/5difficulty
Done 0 of 11
DTC Description

DTC DETECTION LOGIC

DTC No.CONSULT screen terms (Trouble diagnosis content)DTC Detection Condition
B2128

UART COMM

(Universal asynchronous receiver transmitter communication)
Diagnosis condition —
Signal (terminal) —
Threshold Communication between driver seat control unit and automatic drive positioner control unit is interrupted.
Diagnosis delay time A period of time.

POSSIBLE CAUSE

  • UART communication line

    (UART communication line is open or shorted)

  • Driver seat control unit

  • Automatic drive positioner control unit

FAIL-SAFE

Only manual functions, except door mirror, operate normally.

DTC Confirmation Procedure

SELF-DIAGNOSIS WITH AUTOMATIC DRIVE POSITIONER CONTROL UNIT

CONSULT

  1. Ignition switch ON.

  2. Select “Self Diagnostic Result” mode of “AUTO DRIVE POS.”.

  3. Check DTC.

Is the DTC detected?

YES>>

Perform diagnosis procedure. Refer to DTC Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

Diagnosis Procedure

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON.

  2. Select “Self Diagnostic Result” mode of “AUTO DRIVE POS.”.

  3. Erase the DTC.

  4. Perform DTC confirmation procedure. Refer to DTC Confirmation Procedure.

Is the DTC displayed again?

YES>>

GO TO 2.

NO>>

Check intermittent incident. Refer to Intermittent Incident.

CHECK UART COMMUNICATION LINE CONTINUITY

  1. Ignition switch OFF.

  2. Disconnect driver seat control unit and automatic drive positioner control unit.

  3. Check continuity between driver seat control unit harness connector and automatic drive positioner control unit harness connector.

    Driver seat control unit connectorAutomatic drive positioner control unit connectorContinuity
    ConnectorTerminalConnectorTerminal
    B209 15 M33 8 Yes
  4. Check continuity between driver seat control unit harness connector and ground.

    Driver seat control unitGroundContinuity
    Connector Terminal
    B209 15 No

Is the inspection result normal?

YES>>

Check intermittent incident. Refer to Intermittent Incident.

NO>>

Repair or replace harness.