Body Interior

Sliding Switch

14steps
~84min
3/5difficulty
Done 0 of 14
Component Function Check

DATA MONITOR

CONSULT

  1. Select “SLIDE SW-FR”, “SLIDE SW-RR” in “Data Monitor” mode of “AUTO DRIVE POS.”.

  2. Check that the function operates normally according to the following conditions:

Monitor itemConditionStatus
SLIDE SW-FR Sliding switch (forward) Operate ON
Release OFF
SLIDE SW-RR Sliding switch (backward) Operate ON
Release OFF

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Perform diagnosis procedure. Refer to Diagnosis Procedure.

Diagnosis Procedure

CHECK SLIDING SWITCH SIGNAL

  1. Ignition switch OFF.

  2. Check voltage between driver seat control unit harness connector and ground.

(+)(–)Condition

Voltage

(Approx.)
Driver seat control unit
ConnectorTerminals
B209 9 Ground Sliding switch Operate (backward) 0V
Release Battery voltage
25 Operate (forward) 0V
Release Battery voltage

Is the inspection result normal?

YES>>

GO TO 5.

NO>>

GO TO 2.

CHECK SLIDING SWITCH CIRCUIT

  1. Ignition switch OFF.

  2. Disconnect driver seat control unit and power seat switch LH.

  3. Check continuity between driver seat control unit harness connector and power seat switch LH harness connector.

    Driver seat control unitPower seat switch LHContinuity
    ConnectorTerminalConnectorTerminal
    B209 25 B208 7 Yes
    9 8
  4. Check continuity between driver seat control unit harness connector and ground.

    Driver seat control unitGroundContinuity
    ConnectorTerminal
    B209 25 No
    9

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace harness.

CHECK DRIVER SEAT CONTROL UNIT OUTPUT

  1. Connect the driver seat control unit.

  2. Ignition switch ON.

  3. Check voltage between driver seat control unit harness connector and ground.

(+)(–)

Voltage

(Approx.)
Driver seat control unit
ConnectorTerminal
B209 25 Ground Battery voltage
9

Is the inspection result normal?

YES>>

GO TO 4.

NO>>

Replace driver seat control unit. Refer to Removal and Installation.

CHECK SLIDING SWITCH

Refer to Component Inspection.

Is the inspection result normal?

YES>>

GO TO 5.

NO>>

Replace power seat switch LH. Refer to Removal and Installation.

CHECK INTERMITTENT INCIDENT

Refer to Intermittent Incident.

Is the inspection result normal?

YES>>

Replace driver seat control unit. Refer to Removal and Installation.

NO>>

Repair or replace malfunctioning part.

Component Inspection

CHECK SLIDING SWITCH

  1. Ignition switch OFF.

  2. Disconnect power seat switch LH.

  3. Check continuity between power seat switch LH terminals.

    Power seat switch LHConditionContinuity
    Terminal
    3 8 Sliding switch (backward) Operate Yes
    Release No
    7 Sliding switch (forward) Operate Yes
    Release No

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Replace power seat switch LH. Refer to Removal and Installation.