Body Interior

Sliding Motor

9steps
~54min
2/5difficulty
Done 0 of 9
Component Function Check

ACTIVE TEST

CONSULT

  1. Select “SEAT SLIDE” in “Active Test” mode of “AUTO DRIVE POS.”.

  2. Check that the function operates normally.

Test ItemDescription
SEAT SLIDE Off Seat sliding Stop
FR Forward
RR Backward

Is the operation of relevant parts normal?

YES>>

Inspection End.

NO>>

Perform diagnosis procedure. Refer to Diagnosis Procedure.

Diagnosis Procedure

CHECK SLIDING MOTOR LH POWER SUPPLY

CONSULT

  1. Ignition switch ACC.

  2. Select “SEAT SLIDE” in “Active Test” mode of “AUTO DRIVE POS.”.

  3. Check voltage between driver seat control unit harness connector and ground.

    (+)(-)Condition

    Voltage

    (Approx.)
    Driver seat control unit
    ConnectorTerminal
    B210 36 Ground SEAT SLIDE Off 0V
    FR (forward) 0V
    RR (backward) Battery voltage
    44 Off 0V
    FR (forward) Battery voltage
    RR (backward) 0V

Is the inspection result normal?

YES>>

Replace sliding motor LH. Refer to Removal and Installation.

NO>>

GO TO 2.

CHECK SLIDING MOTOR LH CIRCUIT

  1. Ignition switch OFF.

  2. Disconnect driver seat control unit and sliding motor LH.

  3. Check continuity between driver seat control unit harness connector and sliding motor LH harness connector.

    Driver seat control unitSliding motor LHContinuity
    ConnectorTerminalConnectorTerminal
    B210 36 B211 1 Yes
    44 5
  4. Check continuity between driver seat control unit harness connector and ground.

    Driver seat control unit connectorGroundContinuity
    ConnectorTerminal
    B210 36 No
    44

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace harness.

CHECK INTERMITTENT INCIDENT

Refer to Intermittent Incident.

Is the inspection result normal?

YES>>

Replace driver seat control unit. Refer to Removal and Installation.

NO>>

Repair or replace the malfunctioning part.