Body Interior

Tilt Motor

11steps
~66min
3/5difficulty
Done 0 of 11
Component Function Check

ACTIVE TEST

CONSULT

  1. Select “TILT MOTOR” in “Active Test” mode of “AUTO DRIVE POS.”.

  2. Check that the function operates normally.

Test itemDescription
TILT MOTOR Off Steering tilt Stop
UP Upward
DWN Downward

Is the operation of relevant parts normal?

YES>>

Inspection End.

NO>>

Perform diagnosis procedure. Refer to Diagnosis Procedure.

Diagnosis Procedure

CHECK TILT MOTOR POWER SUPPLY

CONSULT

  1. Ignition switch OFF.

  2. Disconnect tilt motor.

  3. Ignition switch ON.

  4. Select “TILT MOTOR” in “Active Test” mode of “AUTO DRIVE POS”.

  5. Check voltage between tilt motor harness connector and ground.

    (+)(–)Condition

    Voltage

    (Approx.)
    Tilt motor
    ConnectorTerminal
    M85 2 Ground TILT MOTOR Off 0V
    UP 0V
    DWN (down) Battery voltage
    1 Off 0V
    UP Battery voltage
    DWN (down) 0V

Is the inspection result normal?

YES>>

Replace tilt motor. Refer to Exploded View.

NO>>

GO TO 2.

CHECK TILT MOTOR CIRCUIT

  1. Ignition switch OFF.

  2. Disconnect automatic drive positioner control unit.

  3. Check continuity between automatic drive positioner control unit harness connector and tilt motor harness connector.

    Automatic drive positioner control unitTilt motorContinuity
    ConnectorTerminalConnectorTerminal
    M34 28 M85 2 Yes
    29 1
  4. Check continuity between automatic drive positioner control unit harness connector and ground.

    Automatic drive positioner control unitGroundContinuity
    ConnectorTerminal
    M34 28 No
    29

Is the inspection result normal?

YES>>

Replace automatic drive positioner control unit. Refer to Removal and Installation.

NO>>

Repair or replace harness.