Body Interior
U1000 Can Comm Circuit
In this manual: Body Interior
5steps
~30min
2/5difficulty
Done 0 of 5
DTC DETECTION LOGIC
| DTC No. | CONSULT screen terms (Trouble diagnosis content) | DTC Detection Condition | |
|---|---|---|---|
| U1000 | CAN COMM CIRCUIT (CAN communication circuit) |
Diagnosis condition | When ignition switch ON. |
| Signal (terminal) | — | ||
| Threshold | — | ||
| Diagnosis delay time | 2 seconds or more | ||
POSSIBLE CAUSE
CAN communication system
FAIL-SAFE
—
STEP 1
Ignition switch ON and wait at least 2 seconds.
>>GO TO 2.
STEP 2
CONSULT
Select “Self Diagnostic Result” mode of “AUTO DRIVE POS.”.
Check DTC.
Is the DTC detected?
YES>>Perform diagnosis procedure. Refer to DTC Diagnosis Procedure.
NO>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>Confirmation after repair: Inspection End.
SELF DIAGNOSTIC RESULT
CONSULT
Ignition switch ON and wait for 2 seconds or more.
Select “Self Diagnostic Result” mode of “AUTO DRIVE POS.”.
Check DTC.
Is DTC “U1000” displayed?
YES>>Refer to Trouble Diagnosis Flow Chart.
NO>>GO TO 2.
CHECK INTERMITTENT INCIDENT
Refer to Intermittent Incident.
>>Inspection End.
Was this page helpful?