Body Interior

Sliding Sensor

17steps
~102min
4/5difficulty
Done 0 of 17
Component Function Check

DATA MONITOR

CONSULT

  1. Select “SLIDE PULSE” in “Data Monitor” mode of “AUTO DRIVE POS.”.

  2. Check that the function operates normally according to the following conditions:

    Monitor itemConditionValue
    SLIDE PULSE Seat sliding Operate (forward) Change (decrease)
    Operate (backward) Change (increase)
    Release No change

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Perform diagnosis procedure. Refer to Diagnosis Procedure.

Diagnosis Procedure

CHECK SLIDING SENSOR SIGNAL

  1. Ignition switch ON.

  2. Read voltage signal between driver seat control unit harness connector and ground with oscilloscope.

    (+)(–)Condition

    Voltage signal

    (Approx.)
    Driver seat control unit
    ConnectorTerminal
    B209 31 Ground Seat sliding Operate
    Other than above 0V or 5V

Is the inspection result normal?

YES>>

Replace driver seat control unit. Refer to Removal and Installation.

NO>>

GO TO 2.

CHECK SLIDING SENSOR CIRCUIT

  1. Ignition switch OFF.

  2. Disconnect driver seat control unit and sliding motor LH.

  3. Check continuity between driver seat control unit harness connector and sliding motor LH harness connector.

    Driver seat control unitSliding motor LHContinuity
    ConnectorTerminalConnectorTerminal
    B209 31 B211 2 Yes
  4. Check continuity between driver seat control unit harness connector and ground.

    Driver seat control unitGroundContinuity
    ConnectorTerminal
    B209 31 No

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace harness.

CHECK SLIDING SENSOR POWER SUPPLY

  1. Connect driver seat control unit.

  2. Ignition switch ON.

  3. Check voltage between sliding motor LH harness connector and ground.

    (+)(–)

    Voltage

    (Approx.)
    Sliding motor LH
    ConnectorTerminal
    B211 4 Ground Battery voltage

Is the inspection result normal?

YES>>

GO TO 5.

NO>>

GO TO 4.

CHECK SLIDING SENSOR POWER SUPPLY CIRCUIT

  1. Ignition switch OFF.

  2. Disconnect driver seat control unit.

  3. Check continuity between driver seat control unit harness connector and sliding motor LH harness connector.

    Driver seat control unitSliding motor LHContinuity
    ConnectorTerminalConnectorTerminal
    B209 5 B211 4 Yes
  4. Check continuity between driver seat control unit harness connector and ground.

    Driver seat control unitGroundContinuity
    ConnectorTerminal
    B209 5 No

Is the inspection result normal?

YES>>

Replace driver seat control unit. Refer to Removal and Installation.

NO>>

Repair or replace harness.

CHECK SLIDING SENSOR GROUND

  1. Ignition switch OFF.

  2. Check continuity between sliding motor LH harness connector and ground.

    Sliding motor LHGroundContinuity
    ConnectorTerminal
    B211 3 Yes

Is the inspection result normal?

YES>>

Replace sliding motor LH. Refer to Removal and Installation.

NO>>

Repair or replace harness.