Body Interior
Power Supply and Ground Circuit. Driver Seat Control Unit
In this manual: Body Interior
3steps
~18min
2/5difficulty
Done 0 of 3
CHECK FUSE
Check that the following fusible link is not blown:
| Signal name | Fusible link No. | Capacity |
|---|---|---|
| Battery power supply | L | 40 A |
Is the inspection result normal?
YES>>GO TO 2.
NO>>Replace the blown fusible link after repairing the affected circuit if a fuse is blown.
CHECK POWER SUPPLY CIRCUIT
Ignition switch OFF.
Disconnect driver seat control unit.
Check voltage between driver seat control unit harness connector and ground.
| (+) | (–) | Condition | Voltage (Approx.) | |
|---|---|---|---|---|
| Driver seat control unit | ||||
| Connector | Terminal | |||
| B210 | 37 | Ground | Ignition switch OFF | Battery voltage |
Is the inspection result normal?
YES>>GO TO 2.
NO>>Check the following:
Repair or replace harness.
Circuit breaker-2.
CHECK GROUND CIRCUIT
Check continuity between the driver seat control unit harness connector and ground.
| Driver seat control unit | Ground | Continuity | |
|---|---|---|---|
| Connector | Terminal | ||
| B210 | 39 | Yes | |
Is the inspection result normal?
YES>>Inspection End.
NO>>Repair or replace harness.
PERFORM ADDITIONAL SERVICE
Perform additional service when removing battery negative terminal.
>>Refer to Work Procedure’.
Was this page helpful?