Ventilation, Heater & Air Conditioner

B2630 Sunload Sensor

17steps
~102min
4/5difficulty
Done 0 of 17
DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
B2630

SUNLOAD SENSOR (SHORT)

(Sunload sensor)
Diagnosis condition When ignition switch is ON.
Signal (terminal) -
Threshold Detected calorie at sunload sensor 1395 w/m2 (1200 kcal/m2·h) or more
Diagnosis delay time -

POSSIBLE CAUSE

  • Sunload sensor

  • A/C auto amp.

  • Harness and connector (The sensor circuit is open or shorted.)

FAIL-SAFE

—

DTC Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON.

  2. Select “Self Diagnostic Result” mode of “HVAC”.

  3. Check DTC.

Is DTC detected?

YES>>

Perform trouble diagnosis for the sunload sensor. Refer to DTC Diagnosis Procedure.

NO>>

Inspection End.

DTC Diagnosis Procedure

CHECK SUNLOAD SENSOR POWER SUPPLY

  1. Disconnect sunload sensor connector.

  2. Ignition switch ON.

  3. Check voltage between sunload sensor harness connector and ground.

    +−

    Voltage

    (Approx.)
    Sunload sensor
    ConnectorTerminal
    M226 2 Ground 5 V

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

GO TO 4.

CHECK CONTINUITY BETWEEN SUNLOAD SENSOR AND A/C AUTO AMP.

  1. Ignition switch OFF.

  2. Disconnect A/C auto amp. connector.

  3. Check continuity between sunload sensor harness connector and A/C auto amp. harness connector.

    Sunload sensorA/C auto amp.Continuity
    ConnectorTerminalConnectorTerminal
    M226 3 M50 26 Yes

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair harness or connector.

CHECK SUNLOAD SENSOR

  1. Reconnect sunload sensor connector and A/C auto amp. connector.

  2. Check sunload sensor. Refer to Component Inspection.

Is the inspection result normal?

YES>>

Replace A/C auto amp. Refer to Removal and Installation.

NO>>

Replace sunload sensor. Refer to Removal and Installation.

CHECK CONTINUITY BETWEEN SUNLOAD SENSOR AND A/C AUTO AMP.

  1. Ignition switch OFF.

  2. Disconnect A/C auto amp. connector.

  3. Check continuity between sunload sensor harness connector and A/C auto amp. harness connector.

    Sunload sensorA/C auto amp.Continuity
    ConnectorTerminalConnectorTerminal
    M226 2 M50 9 Yes
  4. Check continuity between sunload sensor harness connector and ground.

    Sunload sensor—Continuity
    ConnectorTerminal
    M226 2 Ground No

Is the inspection result normal?

YES>>

Replace A/C auto amp. Refer to Removal and Installation.

NO>>

Repair harness or connector.

Component Inspection

CHECK SUNLOAD SENSOR

  1. Ignition switch ON.

  2. Check voltage between A/C auto amp. harness connector and ground.

    (+)(−)
    A/C auto amp.
    ConnectorTerminal
    M50 9 Ground

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Replace sunload sensor. Refer to Removal and Installation.