B2667 Pass Sunload Sensor
DTC DETECTION LOGIC
| DTC No. | CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | |
|---|---|---|---|
| B2667 | PASS SUNLOAD SENSOR (SHORT) (Sunload sensor) |
Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | - | ||
| Threshold | Detected calorie at sunload sensor (passenger side) 2832 W/m2 (2436 kcal/m2·h) or more. | ||
| Diagnosis delay time | - | ||
POSSIBLE CAUSE
Sunload sensor
A/C auto amp.
Harness and connector (The sensor circuit is open or shorted.)
FAIL-SAFE
—
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
Ignition switch ON.
Select “Self Diagnostic Result” mode of “HVAC”.
Check DTC.
Is DTC detected?
YES>>Refer to DTC Diagnosis Procedure.
NO>>Inspection End.
CHECK SUNLOAD SENSOR POWER SUPPLY
Ignition switch OFF.
Disconnect sunload sensor connector.
Ignition switch ON.
Check voltage between sunload sensor harness connector and ground.
+ − Voltage
(Approx.)Sunload sensor Connector Terminal M226 1 Ground 5 V
Is the inspection result normal?
YES>>GO TO 2.
NO>>GO TO 4.
CHECK SUNLOAD SENSOR GROUND CIRCUIT
Ignition switch OFF.
Check continuity between sunload sensor harness connector and ground.
Sunload sensor — Continuity Connector Terminal M226 3 Ground Yes
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair harness or connector.
CHECK SUNLOAD SENSOR
Check sunload sensor. Refer to Component Inspection.
Is the inspection result normal?
YES>>Replace A/C auto amp. Refer to Removal and Installation.
NO>>Replace sunload sensor. Refer to Removal and Installation.
CHECK SUNLOAD SENSOR POWER SUPPLY CIRCUIT FOR OPEN
Ignition switch OFF.
Disconnect A/C auto amp. connector.
Check continuity between sunload sensor harness connector and A/C auto amp. harness connector.
Sunload sensor A/C auto amp. Continuity Connector Terminal Connector Terminal M226 1 M50 36 Yes
Is the inspection result normal?
YES>>GO TO 5.
NO>>Repair harness or connector.
CHECK SUNLOAD SENSOR POWER SUPPLY CIRCUIT FOR GROUND SHORT
Check continuity between sunload sensor harness connector and ground.
| Sunload sensor | — | Continuity | |
|---|---|---|---|
| Connector | Terminal | ||
| M226 | 1 | Ground | No |
Is the inspection result normal?
YES>>GO TO 6.
NO>>Repair harness or connector.
CHECK SUNLOAD SENSOR POWER SUPPLY CIRCUIT FOR POWER SHORT
Ignition switch ON.
Check voltage between sunload sensor harness connector and ground.
+ − Voltage
(Approx.)Sunload sensor Connector Terminal M226 1 Ground 0 V
Is the inspection result normal?
YES>>Replace A/C auto amp. Refer to Removal and Installation.
NO>>Repair harness or connector.
CHECK SUNLOAD SENSOR
Ignition switch ON.
Check input voltage from sunload sensor between A/C auto amp. harness connector and ground. Refer to applicable table for normal value.
+ − A/C auto amp. Connector Terminal M50 36 Ground 
Is the inspection result normal?
YES>>Inspection End.
NO>>Replace sunload sensor. Refer to Removal and Installation.