Ventilation, Heater & Air Conditioner

Door Motor

9steps
~54min
2/5difficulty
Done 0 of 9
Diagnosis Procedure

CHECK EACH DOOR MOTOR POWER SUPPLY

  1. Ignition switch ON.

  2. Check voltage between intake door motor harness connector and ground.

    +−

    Voltage

    (Approx.)
    Intake door motor
    ConnectorTerminal
    M153 1 Ground Battery voltage

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

GO TO 3.

CHECK EACH DOOR MOTOR GROUND CIRCUIT

  1. Ignition switch OFF.

  2. Disconnect intake door motor connector.

  3. Check continuity between intake door motor harness connector and ground.

    Intake door motor—Continuity
    ConnectorTerminal
    M153 2 Ground Yes

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Repair harness or connector.

CHECK EACH DOOR MOTOR POWER SUPPLY CIRCUIT FOR OPEN

  1. Disconnect A/C auto amp. connector.

  2. Check continuity between intake door motor harness connector and A/C auto amp. harness connector.

    Intake door motorA/C auto amp.Continuity
    ConnectorTerminalConnectorTerminal
    M153 1 M50 17 Yes

Is the inspection result normal?

YES>>

GO TO 4.

NO>>

Repair harness or connector.

CHECK EACH DOOR MOTOR POWER SUPPLY CIRCUIT FOR SHORT

  1. Disconnect following connectors:

    • Air mix door motor LH

    • Air mix door motor RH

    • Mode door motor

  2. Check continuity between intake door motor harness connector and ground.

Intake door motor—Continuity
ConnectorTerminal
M153 1 Ground No

Is the inspection result normal?

YES>>

Replace A/C auto amp. Refer to Removal and Installation.

NO>>

Repair harness or connector.