Ventilation, Heater & Air Conditioner
U1010 Control Unit(can)
In this manual: Ventilation, Heater & Air Conditioner
3steps
~18min
2/5difficulty
Done 0 of 3
Initial diagnosis of A/C auto amp.
DTC DETECTION LOGIC
| DTC No. | CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | |
|---|---|---|---|
| U1010 | CONTROL UNIT(CAN) [Control unit (CAN)] |
Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | - | ||
| Threshold | - | ||
| Diagnosis delay time | - | ||
POSSIBLE CAUSE
A/C auto amp.
FAIL-SAFE
—
PERFORM SELF DIAGNOSTIC RESULT
CONSULT
Ignition switch ON.
Select “Self Diagnostic Result” mode of “HVAC”.
Check DTC.
Is DTC detected?
YES>>Refer to DTC Diagnosis Procedure.
NO>>Inspection End.
REPLACE A/C AUTO AMP.
Replace A/C auto amp. Refer to Removal and Installation.
>>Inspection End.
Was this page helpful?