Access to rear seats, two-door version

Manually adjustable seats

Lift handle 2 and slide the seat forward.

To return the seat to position, bring the seatback back upright.

Do not operate handle 1 and handle 2 or switch 3 at the same time.

Power-adjustable seats

Lift handle 2 and fully tilt the seatback forward: the seat moves forward.

To return the seat to position, bring the seatback back upright. The seat returns to its original position.

Load limiter

If an obstacle prevents the seat from returning to its original position, a built-in force limiter stops the seat movement. In this case, switch the seat again, clear the obstacle, then return the backrest to position. The seat will then return to its original position.

As the headrest is a safety feature, make sure it is present and correctly positioned: the top of the headrest should be as close as possible to the top of the head and the distance between the head and the headrest should be minimal.

In some cases, it may be necessary to change the seat settings to allow access to the rear seats.

Risk of interference with the vehicle roof lining.

Make sure
nothing obstructs the front seat's movement.

Driver's seat with memory

Three driving positions can be stored.

A driving position includes the settings of the driver's seat cushion, backrest and exterior mirrors.

Operation

Storing and recalling the driving position using the buttons is possible:

• 'hands-free' card detected or, depending on vehicle, RENAULT card in the card reader;
• when the driver's door is opened.

Storing the driving position

Adjust the seat using switches 4 and 5 (see previous page).

Adjust the exterior mirrors (refer to the 'Mirrors' section in chapter 1). Press button 1, 2 or 3 until you hear a beep: the driving position (seat and exterior mirrors) is stored.

To store other driving positions, repeat this procedure for each of buttons 1, 2 and 3.

Recalling a stored driving position

With the vehicle stationary, briefly press button 1, 2 or 3 depending on the stored driving position you want.

Note: recalling the stored driving position is interrupted if any seat adjustment button is pressed during recall.

A driving position cannot be recalled while the vehicle is moving.

For
safety reasons, make these adjustments with the vehicle stationary.

To avoid impairing the effectiveness of the seat belts, we advise you not to recline the seatbacks too far.

No objects should be placed on the floor (driver's front footwell): in the event of hard braking, such objects may slide under the pedals and prevent their use.