Front headlamps (replacing bulbs)

Five-door version

Because removing protective covers is required, we recommend having your bulbs replaced by a brand Representative.

Before
working in the engine compartment, be sure to switch off the ignition by pressing the engine stop button (refer to the 'Starting and stopping the engine' section in chapter 2).

Dipped / main beam halogen bulbs

Remove cover A or B, then unclip bulb holder 2 by pressing connector 1, and pull the assembly out of its housing, or remove spring 5 then connector 4 from bulb 3.

Bulb type: you must use 55W anti-U.V. bulbs to avoid degrading the plastic lens of the headlamps.

Bulb type for bulbs 2 and 3: H7.

Do not touch the glass of the bulb.

Hold it by its base.

After replacing the bulb, make sure the cover is correctly refitted.

Front position light

Note: the position light bulb 6 is deactivated, there is no need to replace it.

Turn indicator light

Consult a Renault dealer.

The bulbs
are pressurised and may burst when replaced.

Risk of injury.

When working near the engine, it may be hot. In addition, the cooling fan may start at any time.

Risk of injury.

Five-door version (continued)

D xenon dipped beam bulbs

Bulb type: D1S.

Due to the
danger of handling high-voltage components, this type of bulb must be replaced by a Renault dealer.

Daytime / front position light

Note: the daytime running and position light bulbs under cover C are deactivated, there is no need to replace them.

Turn indicator light

Consult a Renault dealer.

Depending on local legislation, or as a precaution, obtain an emergency kit from a Renault dealer containing a set of bulbs and a set of fuses.Fitting
this equipment requires specific technology, so it is forbidden to fit a headlamp fitted with xenon bulbs to a version not designed to accept this equipment.

Daytime / position lights 9

Consult a Renault dealer.

Front fog lights 10 (depending on vehicle)

Because removing the front bumper is required, we recommend having your bulbs replaced by a brand Representative.

The bulbs
are pressurised and may burst when replaced.

Risk of injury.

Any
work on (or modification of) the electrical circuit must be carried out by a Renault dealer, who has the parts needed for the adaptation, as an incorrect connection could damage the electrical system (wiring, components, in particular the alternator).

Two-door version

Because removing components (the battery, its support, etc.) is required, we recommend having your bulbs replaced by a brand Representative.

Before
working in the engine compartment, be sure to switch off the ignition by pressing the engine stop button (refer to the 'Starting and stopping the engine' section in chapter 2).

Daytime running lights A, front position lights B and turn signal lights D

Consult a Renault dealer.

Xenon dipped beam bulbs C

Bulb type: D1S.

Because fitting this kit requires specific technology, it is forbidden to fit a headlamp fitted with xenon bulbs to a version not designed to accept this kit. Depending on local legislation or as a precaution, obtain from a brand Representative an emergency kit containing a set of bulbs and a set of fuses.Due to the
danger of handling high-voltage components, this type of bulb must be replaced by a Renault dealer.When working near the engine, it may be hot. In addition, the cooling fan may start at any time.

Risk of injury.