Inner rear wheel arch

Replacement of this part is an additional operation to replacing the rear wheel arch closing panel for a rear side collision.

Information on related parts is covered in their respective sections (see contents).

Note: If the spot welds cannot be made with the spot welder, they may be replaced with plug welds.

REPLACEMENT PART CONTENTS

Supplied pre-assembled with:
Rear wheel arch rear section
Light bracket inner panel
Welded stud
Upper rear seatback mounting bracket
Left-hand side:
Inner rear wheel arch stiffener
Right-hand side:
Multimedia unit mounting bracket
Weld nut

PARTS CONCERNED (thickness in mm):

1. 1
   Inner rear wheel arch 0.7
2. 2
   Light bracket lining 1
3. 3
   Rear wheel arch rear section 0.7
4. 4
   Lower rear end cross member, side section 1.2

PART IN POSITION

Note: The rear section of the rear wheel arch is available from the spare parts store, so in the case of a very localised impact it is possible to replace only the rear section of the rear wheel arch.