Fuse inspection and replacement

If any electrical component does not work, a fuse may have blown. If this occurs, inspect and replace all necessary fuses.

1. Vehicles without smart entry & start system: Set the key to the "LOCK" position in the ignition switch.

Vehicles with smart entry & start system: Turn the engine switch off.

After a system failure, refer to the "Fuse Layout and Ratings" section for details on the fuse to check.

Open the fuse box cover.

Engine compartment

Press the tabs and lift up the cover.

Driver's side instrument panel

Remove the cover.

4. Remove the fuse using the fuse puller.

Only type A fuses can be removed using the fuse puller.
5. Check whether the fuse is blown.

1. 1
   Normal fuse
2. 2
   Blown fuse

Type A, B and C: Replace the blown fuse with a new fuse of the correct amperage rating.

Type D: Contact any Toyota dealer or repair shop, or another suitably qualified and equipped professional.

Type A

Type B

Type C

Type D

Fuse layout and ratings

■ Engine compartment

*1: HM01 engine
*2: 1KR engine
*3: Vehicles with multi-mode manual transmission
*4: Vehicles with idling stop system
*5: Replace the fuse with one of the same amperage as the original

■ Driver's side instrument panel

*1: 1KR engine
*2: HM01 engine
*3: Left-hand drive vehicles
*4: Right-hand drive vehicles

■ After replacing a fuse

• If the lights still do not come on after replacing the fuse, a bulb may need to be replaced.
• If the replaced fuse blows again, have the vehicle inspected by any Toyota dealer or repair shop, or another suitably qualified and equipped professional.

■ If a circuit is overloaded Fuses are designed to blow in order to prevent damage to the entire wiring harness.

WARNING

■ To prevent system malfunction and vehicle fire Observe the following precautions.

Failure to observe these precautions may result in vehicle damage, fire or injury.

• Never use a fuse with a higher amperage rating than specified, or use any other object in place of a fuse.
• Always use genuine Toyota fuses or equivalent.

Never replace a fuse with wire, even as a temporary measure.

Do not modify the fuses or fuse boxes.

NOTE

■ Before replacing fuses Have the cause of the electrical overload determined and repaired as soon as possible by any Toyota authorized dealer or repairer, or another suitably qualified and equipped professional.