Wiper / Washer
How to Use Troubleshooting
In this manual: Wiper / Washer
~1min read
PRECAUTION / NOTICE / HINT
HINT:
- Follow the procedure below to troubleshoot the wiper and washer system.
- *: Use the Techstream.
PROCEDURE
VEHICLE BROUGHT TO WORKSHOP
|
CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CONFIRMATION
|
CHECK BATTERY VOLTAGE
(a) Measure the battery voltage.
Standard voltage:
11 à 14 V
If the voltage is below 11 V, charge or replace the battery before proceeding to the next step.
|
SYMPTOM TROUBLESHOOTING TABLE
(a) Refer to the Symptom Troubleshooting Table.
Click here
![]()
Result:
Result | Proceed to |
|---|---|
The malfunction is not listed in the Symptom Troubleshooting Table. |
A |
The malfunction is listed in the Symptom Troubleshooting Table. |
B |
| B | REFER TO SYMPTOM TROUBLESHOOTING TABLE |
|
GENERAL INFORMATION AND TROUBLESHOOTING
(a) DATA LIST / ACTIVE TEST
Click here![]()
(b) ECU Terminals
Click here
![]()
(c) Inspection
(d) Vehicle Inspection
|
ADJUST, REPAIR OR REPLACE
|
CONFIRMATION TEST
| NEXT | END |
Was this page helpful?