Wiper / Washer

Operation Check

~2min read

OPERATION CHECK

FRONT WIPER MOTOR AND LINKAGE ASSEMBLY INSPECTION

(a) AUTOMATIC wiper inspection (with rain sensor)

(1) Continuously apply water to the windshield in front of the rain sensor.

(2) Turn the ignition switch ON.

(3) Move the front wiper switch assembly to the AUTO position.

(4) Make sure the wipers move.

(b) Intermittent wiper inspection (without rain sensor)

(1) Turn the ignition switch to ON.

(2) Turn the front wiper switch assembly to the INT position.

(3) Make sure the wipers move intermittently.

WASHER PUMP AND MOTOR ASSEMBLY INSPECTION

(a) Front washer operation inspection

(1) Turn the ignition switch to ON.

(2) Operate the front washer switch for approximately 0.5 second minimum and make sure the front wipers operate in LO position while washer fluid is sprayed, and that the front wipers operate for 3 cycles after the front washer switch is released.

(b) Rear washer operation inspection

(1) Turn the ignition switch to ON.

(2) With the front wiper switch assembly (rear wiper control switch) in the OFF position, operate the rear washer switch for approximately 0.5 second minimum and make sure the rear wiper operates while washer fluid is sprayed.

(3) Make sure the rear wiper operates for approximately 2.5 seconds after the rear washer switch is released.

(c) Wiper drip prevention function

(1) Turn the ignition switch to ON.

(2) When the vehicle is traveling at a speed below approximately 4 km/h, make sure the front wipers operate for 1 cycle of approximately 3 seconds after the washer linked operation ends.

REAR WIPER MOTOR AND DELAY ASSEMBLY INSPECTION

(a) Turn the ignition switch to ON.

(b) Turn the front wiper switch assembly to the INT position.

(c) Make sure the rear wiper operates approximately once every 12 seconds.