Wiper / Washer

Data List / Active Test

~1min read

DATA LIST / ACTIVE TEST

DATA LIST

HINT:

The Techstream Data List allows you to read the values or status of switches, sensors, actuators and other components without removing any parts. This non-intrusive check can be very useful, since intermittent conditions or signals can be identified before parts or wiring are moved. Reading the Data List during troubleshooting saves time in diagnosis.

NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not determine whether a part is faulty based only on these reference values.

(a) Turn the ignition switch OFF.

(b) Connect the Techstream to the DLC3.

(c) Turn the ignition switch to ON.

(d) Turn on the Techstream.

(e) Select the following menus: Body Electrical / Combination Meter / Data List.

(f) Read the Data List according to the Techstream display.

Body Electrical > Combination Meter > Data List

Tester display

Item

Range

Normal Condition

Diagnostic Note

Washer Switch

Level warning switch condition

ON / OFF

ON: Washer fluid volume is less than 600 to 800 cm3 (36.6 to 48.8 in3)

OFF: Washer fluid volume is more than 600 to 800 cm3 (36.6 to 48.8 in3)

with washer fluid level warning system