How to Use Troubleshooting
PRECAUTION / NOTICE / HINT
HINT:
- Perform the following procedure to troubleshoot the occupant classification system.
- *: Use the Techstream.
PROCEDURE
VEHICLE BROUGHT TO WORKSHOP
|
CUSTOMER PROBLEM ANALYSIS
(a) Confirm the malfunction symptoms.
Click here
![]()
|
CHECK CAN COMMUNICATION SYSTEM*
(a) Using the Techstream, check whether the CAN communication system operates normally.
OK:
The CAN communication system operates normally.
HINT:
- Refer to the CAN Bus Check section in the CAN communication system.
Click here
.gif)
- The occupant detection ECU is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure there is no malfunction in the CAN communication system.
| NG | GO TO CAN COMMUNICATION SYSTEM |
|
PASSENGER AIRBAG ON/OFF INDICATOR LIGHT CHECK
(a) Refer to the "Diagnostic System" section.
Click here![]()
|
CHECK DTCs (current and history DTCs)*
(a) Refer to Check / Clear DTCs.
Click here![]()
OK:
No DTCs are output.
| OK | REFER TO SYMPTOM TROUBLESHOOTING TABLE |
|
DTC CHART
(a) Refer to the DTC Chart.
Click here![]()
|
CIRCUIT INSPECTION*
|
REPAIR
|
CLEAR DTCs (past and history DTCs)*
(a) Refer to Check / Clear DTCs.
Click here![]()
|
CHECK DTCs*
(a) Refer to Check / Clear DTCs.
Click here![]()
OK:
No DTCs are output.
| NG | GO TO STEP 6 |
|
SIMULATE SYMPTOMS
(a) Check the operation of the passenger airbag ON/OFF indicator.
|
CONFIRMATION TEST
| NEXT | END |